For more details, please see ourCookie Policy.

Management Software

Posts: 0

fabos not yet initialized

Checking system RAM - press any key to stop test

Checking memory address: 00100000

System RAM test using Default POST RAM Test succeeded.

set_bootstatus: BS_LOAD_OS, platform_idx = 1

Type run flash_nfs to mount root filesystem over NFS

Hit ESC to stop autoboot:  0
Map file at LBA sector 0x183e10
## Booting image at 00400000 ...
   Image Name:   Linux-
   Image Type:   PowerPC Linux Multi-File Image (uncompressed)
   Data Size:    4269595 Bytes =  4.1 MB
   Load Address: 00000000
   Entry Point:  00000000
   Image 0:  3190917 Bytes =  3 MB
   Image 1:  1078663 Bytes =  1 MB
## Current stack ends at 0x1FAEEBE8 => set upper limit to 0x00C00000
## initrd at 0x0070B0D4 ... 0x0081265A (len=1078663=0x107587)
   Loading Ramdisk to 1f9e6000, end 1faed587 ... OK
 initrd_start = 1f9e6000, initrd_end = 1faed587
## Transferring control to Linux (at address 00000000) ...
Installing Linux 2.6 Kernel
Attempting to find a root file system on hda2...
INIT: version 2.78 booting
Bypassing firmware validation.
--- Partition /dev/hda1 is inconsistent.
--- Its content will be restored to be the same as that of /dev/hda2.
--- Please check the version and re-load firmware if necessary after the system boots up.
INIT: Entering runlevel: 3
Starting Fabric OS Services...
FIPS off, RRD...
*                                                            *
* System booted     5 times within    3000 seconds!          *
*                                                            *
* Fabric OS has detected frequent switch reboot condition.   *
* Following actions can be taken to recover the switch:      *
* - remove or replace any problem blades (if applicable to   *
*   platform).                                               *
* - use supportsave to collect supportsave data.             *
*                                                            *


sysmodAttach open failed: No such device or address
fabsys device open: No such device or address
Raslog Module Initialisation failed rc=-1
fabsys device open: No such device or address

Join the Broadcom Support Community

Get quick and easy access to valuable resources across the Broadcom Community Network.