Hi Community,
I opened the ticket in this section of the forum because I can't find the correct one for the Brocade SAN Switches.
I have a synergy HP with 2 san switch brocade, one switch is accessible via http and the other one no.
How i can check if http service is enabled or configured?
If is not configured the access via HTTP how i can enable it?
I can access via SSH with admin user, here below the version installed:
syn1todown:admin> version
Kernel: 2.6.34.6
Fabric OS: v8.2.1
Made on: Tue Aug 28 00:30:35 2018
Flash: Thu Nov 15 17:17:09 2018
BootProm: 2.0.42
syn1todown:admin>
Thx in advanced for support
Regards
Angelo