Hi All,Can someone please help me to understand if I am doing anything wrong in Client subnet based source NAT configuration. Below is the base config:
configure terminalvlan 100 name VIP_VLAN untag eth1 router-interface ve 10 exitinterface ve 10 ip address 192.168.200.1 255.255.255.0 exitvlan 201 name REAL_VLAN untag eth2 router-interface ve 20 exitinterface ve 20 ip address 192.168.201.100 255.255.255.0 exitserver real Web1 192.168.201.10port http udp-onlyexitserver real Web2 192.168.201.11port http udp-onlyexitserver virtual basicslb.com 192.168.200.2 port http udp-only bind http Web1 http Web2 httpexit
To enable SNAT with specific IP, I have tried to add below options: 1. Below command doesn't do NAT at all.
server source-nat client-subnet 10.10.0.0 255.255.0.0 192.168.201.100
2. Below commands doens't do NAT at all:
server source-nat-ip 192.168.201.200 255.255.255.0 0.0.0.0 port-range 2server source-nat client-subnet 10.10.0.0 255.255.0.0 192.168.201.200
3. If I enable "server source-nat" then it does NAT but not with 192.168.201.200 but SVI IP. Any lead would be really helpful
@Atul Choudhary - we do not support Brocade questions on the Community. Please refer to Brocade Global Support (broadcom.com) Thank you Jason McClellan, Platform Admin
@Jason McClellan I am not sure if customer has contract to open a case with Broadcom. Is there any alternate way to get community help or if there is any other community for Brocade ADX?
@Atul Choudhary - unfortunately, no - Brocade direction is directly through their customer support link with no community support. ~jm