If you need to get an overview of all SMRT settings then you can use the ACL SMRTPRT which we deliver in ‘hlq.CB0VSCRI’. Now that ACL goes through the SMRT panels and ‘prints’ them into the TPXLOG. From there you can review/copy them. But this ACL only selects the currently used SMRT, indicated by the string “STARTUP” in the “TPX System Options Table List”.
What can be done if you want to “print” one of the other SMRT’s? That is easy and requires only one change in that ACL SMRTPRT:
First, you need to access the list of SMRT’s in TPXADMIN, option 2, then option 1:
TPX System Options Table List
Table Last updated by Userid
SMRTACF 02/03/15 04:52:59 USER01
SMRTBACK 05/20/14 04:52:59 USER01
SMRTTEST 11/25/14 07:53:19 USER01 STARTUP
SMRTXA 07/29/13 06:14:40 TPXADMIN
SYSAPROD 07/29/13 06:14:53 TPXADMIN
SYSATEST 07/29/13 06:15:08 TPXADMIN
SYSBTEST 07/29/13 06:15:24 TPXADMIN
*********************** BOTTOM OF DATA ******************
If your desired SMRT is located above the currently used SMRT, then remember the number of lines you have to go up from the current one. (Example: You want to print SMRTACF, then you need to go up two lines from the current SMRT SMRTTEST).
If your desired SMRT is located below the currently used SMRT, then remember the number of lines you have to go down from the current one. (Example: You want to print SYSATEST, then you need to go down three lines from the current SMRT SMRTTEST).
Now create a copy of the ACL SMRTTEST and locate this block in the ACL:
SELSTRT WAIT 1 * Waits for screen
SET CURSOR,'&LOC' * Places cursor at 'STARTUP'
TABB 1 * Tabs back to option table
KEY 'S' * Selects that option table
ENTER * Sends the selection
Behind the command TABB 1 you insert a new line and put command UP 2 or DOWN 3 there:
DOWN 3 * Go down to desired SMRT
Reload that ACL and execute it: You will find that SMRT printed in the TPXLOG!