View Only
  • 1.  Testing CA Allocate

    Posted Jul 07, 2016 04:01 PM

    hi Team,

    Are there testing procedures to test the CA Allocate product in general and not in terms of storage perspective.



  • 2.  Re: Testing CA Allocate
    Best Answer

    Broadcom Employee
    Posted Jul 08, 2016 01:19 AM

    Hello Rohith,


    Unfortunately not yet. You can validate the ASR rules by using the sample JCL located here: CCTVJCL(TESTASRS).

    This is a good request. I will make sure the product owner to be aware of it.


    Now as a circumvention, you can test, based on a filter with your userid, any specific rule change. This impacts only you and not the production.

    As an example, if you code such rule in VDSPROG (replace "userid" by your userid) :

    IF &USER = 'userid' THEN DO  

        COPYBOOK 'userid'         


    This permits to enter to your test environment and perform all the tests validation you would like. Of course the COPYBOOK member is the place you write your own ASR test code.



    Pierre Montel                

  • 3.  Re: Testing CA Allocate

    Posted Jul 08, 2016 10:05 AM

    Hi Pierre,

    Thanks for the Information.

    One more thing, Including ca allocate there are other storage products like ca1 tape management, ca vantange, ca disk, ca copycat. As sys progs there will be need to roll out the tested new maintenance to other set(production) libraries. When testing the new maintenance the storage team would be involved and they would test it from their end. But when promoting to other set of libraries as storage team would not be involved, we need to have few testing procedures to test the product and confirm our roll out to other set is fine.

    It would be helpful if I could get the general testing procedures for these products maintained in our environment.

    Thanks Again.


  • 4.  Re: Testing CA Allocate

    Broadcom Employee
    Posted Jul 11, 2016 08:28 AM

    Hi Rohith,


    For CA1 R14 or R12.6, the IVP test job is located into CTAPJCL(TMSIVP). You can customize it to validate the labels you use.


    For CA Vantage, there is no validation process. Basically, if it starts without abend or error messages, you are good. The second point to check, is if you can logon to the Gui (Windows client) or WebUI (Browser interface) and get data.

    This product has an MSGE associated to its STC which contains all error messages traces. If nothing special there then the product works fine.


    For CA Disk, you have a complete IVP set available into the CCUWJCL. The members all starts with IVP. Running it from 01 to 10 will do a complete product check and validation on basic functrion.


    For CA Copycat, there is no validation process. Now you can create one based on what process you often use.


    Let me know if you need anything else.

    Best regards,


  • 5.  Re: Testing CA Allocate

    Posted Jul 11, 2016 08:57 AM
      |   view attached

    hi Pierre,


    Thanks a lot for the Information and support provided.

                                                                                    Thanks and Regards,                                                                               

    Rohith K M                                                                       

    z/OS Systems Programmer                                                                               

    Mobile: 919663825359                                                              


    Plot No 3 Epip(whitefield) Ind

                                                                   Bangalore, KA 560066