20.3 - AJP connector disabled as IP Address is Blank or incorrect

[Nick Barlow]

Hi,

After upgrading from 10.1 to 10.3, I am unable to get the ajp_listener to start, so I added the following lines:

 <ajp_connector>
secretRequired = false
</ajp_connector>



It gets past the previous failure , but now has new failures

Oct 05 13:35:03:770 INFO [main, com.nimsoft.nimbus.probe.service.wasp.Probe] AJP connector uses AJP/1.3 protocol handled by org.apache.coyote.ajp.AjpNioProtocol
Oct 05 13:35:03:770 INFO [main, com.nimsoft.nimbus.probe.service.wasp.Probe] AJP connector max threads 250
Oct 05 13:35:03:770 INFO [main, com.nimsoft.nimbus.probe.service.wasp.Probe] AJP connector secretRequired from CFG : false
Oct 05 13:35:03:771 INFO [main, com.nimsoft.nimbus.probe.service.wasp.Probe] AJP connector secretRequired = false
Oct 05 13:35:03:771 INFO [main, com.nimsoft.nimbus.probe.service.wasp.Probe] AJP connector disabled as IP Address is Blank or incorrect

I have tried adding
address = <ump local address> (only has 1 nic)
It does show AJP connector address = <ump local address> but still show the "is Blank or incorrect" error

Any suggestions please ?

[David Michel]

Check the probe raw configure for a IP address setting. 
This is the only reference to ajp_listener in communities, cases, & KB docs, so it will probably be necessary to check with whoever supplied it. 

------------------------------
Support Engineer
Broadcom
------------------------------

[Nick Barlow]

Thanks for reply.

I have searched google for the error message and do not return any matches. I've also tested this on a second system and the same message exists.
It looks to be Broadcom wasp specific.

[Nick Barlow]

Fix it.. it was in the original error: ajp_ip = <ump address>

[Nick Barlow]

It's another easy to find, once you know what you're looking for:
https://knowledge.broadcom.com/external/article/191489/uim-ump-201-reverse-proxy-not-connectin.html