Upgrade of CA Spectrum from 9.3 to 10.1.1 : SDC Communication Problem

[Anon Anon]

Upgrade of CA Spectrum from 9.3 to 10.1.1 : Upgrade performed in steps from 9.3 to 9.4 to 10 to 10.1 then to 10.1.1. However after the upgrade the SDC cannot communicate. The SDC was also upgraded to 10.1.1 . How do I upgrade to 10.1.1 and get the SDC to communicate as normal?

 

With the version 9.3 Spectrum and the SDC version 9.3 currently comunications are working perfectly and we are able to communicate to that site.

[Tarun Pamu]

How is the configuration specified in the config files? Is it specified in the below format?

 

sdc.config : -nosecure -connect <SDM IP>

sdm.config : -nosecure -remc <SDC IP>

 

If yes can you change this to the below one and see it that works?

 

- on SDC connection in sdc.config : -nosecure -accept <SDM IP>

- on SDM manager in sdm.config : -nosecure -remc <SDC IP>

[Anon Anon]

The below shows the config that is being used.

 

sdc.config :  -connect<SDM IP>

sdm.config :  -remoteaccept <SDC IP>

 

Will try your suggestion. Thank you.