Service Operations Insight

Expand all | Collapse all

Could not remove UIM connector from SOI

Jump to Best Answer
  • 1.  Could not remove UIM connector from SOI

    Posted 08-09-2016 08:48 AM

    Hi Guys,

     

    I have CA SOI 4.0 and integrated with UIM connector 3.6.

    I would like to remove the UIM connector from SOI but the connector still exists and I can't do anything for the connector.

    Please kindly see below picture:

    Is there any advise for me?

    Brahma MichaelBoehm

     

    Best Regards,

    Okik Setianto



  • 2.  Re: Could not remove UIM connector from SOI

    Broadcom Employee
    Posted 08-09-2016 09:05 AM

    Hello Okik,

     

    You may remove this entry from ConnectorConfiguration table if it is still showing on the Admin dashboard.

    Please refer below community thread on the same topic & solution.

    SOI duplicate entries in SOI connector status

     

    Thanks

    Brahma



  • 3.  Re: Could not remove UIM connector from SOI

    Posted 08-10-2016 12:03 AM

    Hello Brahma,

     

    Thanks for the reply. I had done the steps and the entry have been successfully removed, but I got a new problem, when I tried to start catalyst connector, I didn't see connector for UIM exists on the Admin Dashboard.

     

    Do you have any suggestion for me?Brahma

     

    Best Regards,

    Okik



  • 4.  Re: Could not remove UIM connector from SOI
    Best Answer

    Broadcom Employee
    Posted 08-10-2016 04:27 AM

    Hello Okik,

     

    Stop Catalyst Container Services and then delete all files inside \Catalyst\CatalystConnector\container\nls-store\*.

    Then start Container services on the connector server.

     

    Thanks

    Brahma



  • 5.  Re: Could not remove UIM connector from SOI

    Posted 08-10-2016 06:59 AM

    Hello Brahma,

     

    Thank you very much, the connector is online after removed all files inside \nls-store\*.

     

    Best Regards,

    Okik Setianto