DX Application Performance Management

Expand all | Collapse all

How to select agents in Triage Map

  • 1.  How to select agents in Triage Map

    Posted 12-09-2013 07:13 AM

    Dear All,
    I have one question.
    How to select agents on "Triage map"?

    I selected one module of my application in "By Frontend", on "Triage Map".
    But in Overview of my module, is considered all agents.
    I want to display only data of some agents.


    How i do?

    Thanks.

    Vinicius Campelo



  • 2.  RE: How to select agents in Triage Map

    Broadcom Employee
    Posted 12-09-2013 11:48 PM

    Hi Vinicius,

    Is this what you are looking for:

    To see metrics for an individual agent which is monitoring the application:

    1. Select a frontend under the By Frontend node.
    2. In the application triage map tab, right-click the map node representing the same frontend.
    3. Select Show locations for "<Element_Name>".

      In the lower part of the Overview tab, Workstation displays a list of individual physical locations where an instance of the frontend is installed

    Thanks

    Anu

    Principal Support Engineer

    CA APM Support

     

     

     

     



  • 3.  RE: How to select agents in Triage Map

    Posted 12-10-2013 04:52 AM

    Hi Anu,

    Thanks for your tip, but there is the possibility that the map shows only the information, for example, two agents from the list?

    Att,

    Vinícius Campelo



  • 4.  RE: How to select agents in Triage Map

    Broadcom Employee
    Posted 12-11-2013 12:49 AM

    Hi Vinicius,

    I am not aware of a way to do this. However, I will check and get back to you.

     

    Best Regards

    Anu



  • 5.  RE: How to select agents in Triage Map

    Posted 12-11-2013 06:22 AM

    Hi Anu,

    Thank you once again.

    Att,

    Vinícius Campelo



  • 6.  Re: How to select agents in Triage Map

    Broadcom Employee
    Posted 11-12-2015 08:49 PM

    Marking as answered.