Firewall Connection Statistics MF in DX PM Doubt

[Bruno Sousa]

Hello,

I put 2 KPIs from the Firewall Connection Statistics MF logging.

The MF is supported by the firewall device.

When I try to add any of these 2 KPIs in a dashboard (using for example Im Report on demand view) I don't see any way to put them on the dashboard.

I queried these 2 KPIs from a MIB Browser and I get results from both.

Any suggestion on what might be happening?

Thank you.

BR
Bruno Sousa

[Catalin Farcasanu]

Enable debug for the device and check if the values are collected correctly from the device itself. The debug log should present all the values that should be stored to the DB.

------------------------------
Senior Consultant
SolvIT Networks
------------------------------

[Jeffrey Pinard]

As was said, use http://DA:8581/dcdebug and do detailed poll logging for the IP and poll group.
You can get the poll group by viewing the polling config for the IP in dcdebug. 

This way it limits the debug to only that MF and easier to review.
See if the KPIs are NULL in the final result returned to DA each poll cycle.

[Bruno Sousa]

Hello

Used the DC debug and the OIDs are showing results (they're not null)

The KPIs don't appear to be available for selection in the dashboards views, though.

Any suggestion?

Thank you.

BR
Bruno Sousa

[Jeffrey Pinard]

Are you using a group as the context, that contains devices that support the MF in question?

When editing a view, the group context controls what MF are visible.    Do you see the MF even shown?  
Does the MF show but not the metrics you want?
What type of view are you creating?

[Bruno Sousa]

Hi Jeffrey

I was doing this at a device context level in the present.

I tried some views: IM On Demand / Table Top / Dynamic Trend.

The KPIs are not available for selection.

The KPIs that appear for selection are from other VC that is also in this MF.

Thank you.

BR
Bruno Sousa