DX NetOps

 View Only
  • 1.  How to set OneClick HA in CA Spectrum?

    Posted Dec 14, 2018 03:41 AM

    Hi Experts,

     

    Good Afternoon.

     

    How to setup OneClick HA or FT in CA Spectrum?

     

    Thanks & Regards,

    Mudit



  • 2.  Re: How to set OneClick HA in CA Spectrum?
    Best Answer

    Posted Dec 14, 2018 08:11 AM

    OneClick itself is not fault tolerant. It is recommended to use a load balancer. Reference Load Balancers - CA Spectrum - 10.3 - CA Technologies Documentation 

     

    Joe



  • 3.  Re: How to set OneClick HA in CA Spectrum?

    Posted Dec 15, 2018 11:23 PM

    Hi Joe,

     

    Thanks for your response.

    I already gone through that document. I have one confusion is secondary OneClick will also report to MLS SpectroServer ? during installation I need to select MLS as reporting SpectroServer?. Does Secondary OneClick will also work as Primary OC when it will goes down. All OC IPs will define in Load balancer end right.

     

    It's a Hot FT Setup.

     

    Regards,
    Mudit



  • 4.  Re: How to set OneClick HA in CA Spectrum?

    Posted Dec 17, 2018 08:22 AM

    Mudit,

     

    Yes, the secondary OneClick will point to the same MLS. Is is also best practice to specify a backup MLS. 

     

    Your particular load balancer will dictate how to set this up. It is not a Spectrum configuration.

     

    Joe



  • 5.  Re: How to set OneClick HA in CA Spectrum?

    Posted Dec 27, 2018 07:47 AM