Well, this applies to gigamon and anything else.
I created a group under ncm for gigamon.
in the running commands box i put in
enable
show running-config
when you login to a gigamon it is very simular to a cisco device you get a . prompt and you have to enter the word enable in order to use real commands. < no pass required>
I did not want to go thru creating a huge custom script in order to make this work. Does anyone have any real world examples on how to make this " new feature" work?
I also had to add some ! into the command box so the enable command would take.
so after doing the below i got the beginning of an output but it did not complete.
!
!
enable
!
show running-config
===============
[?1h =
##
## Running database "initial"
## Generated at 2019/03/27 11:08:32 -0500
## Software version on which this output was taken: GigaVUE-OS 5.1.04 99332 2018 -08-02 13:37:48
## Hostname: xxxxxxxxxx
##
## Note: If you are not an admin user some command invocations may be omitted
## because you do not have permissions to see them.
##
##
## Network interface configuration
##
interface eth0
create
comment ""
no dhcp
display
duplex auto
ip address 10.x.x.x/24
mtu 1500
no shutdown
[7mlines 1-22 [m [K
[K speed auto
[7mlines 2-23 [m [K
so..... what needs to be done here?