DX NetOps

Expand all | Collapse all

RIB Query to list polling records of Interface Utilization

Jump to Best Answer
  • 1.  RIB Query to list polling records of Interface Utilization

    Posted 09-04-2014 08:22 AM

    Hi all,

     

    Is it possible to create a RIB Query that list polling records of Interface Utilization of all routers interfaces?

     

    Thank you



  • 2.  Re: RIB Query to list polling records of Interface Utilization

    Posted 10-30-2014 03:47 PM

    Hello Mamelli,

     

    Are you looking to extract the data for Interface element utilization from Data Aggregator polled interface elements?

     

    If so rather than a RIB query you may want to look into the Data Aggregator Bulk Export functionality. Note that in the 2.3.4 base and earlier releases the interface names extracted are difficult to differentiate from each other.

     

    As of the 2.3.4 October Update Kit an improvement was made to provide more meaningful interface names in the bulk data export data.

     

    If you must use RIB for this query, it can be helpful to review the RIB query the software issues from CAPC UI Dashboard Views. Once that is identified it becomes much easier to take that default query and modify it to meet your needs. To figure out the RIB query the UI issues check out this recently published Knowledge Base Article TEC1285334 (it should be published and available within the next week or two). Until it is published and able to be viewed here are the basic details:

     

    Hope that helps answer your question.

     

    Thanks,

    Mike

     

    This is known as the "Blue Bars" debug trick. To do so first open a new browser and launch the URL:

    http://CAPC_HOST:8181/pc/center/admin/debug/attrs

    Replace CAPC_HOST with your CAPC systems host name or IP address.

    When the page loads it may request a log in with a username and password. The default is:

    UserName: admin
    Password: admin

    Scroll down and find the "RIBModelInfoEnabled" option. In the Value column change the default from False to True to enable the function. At the top or bottom of the debug settings page will be an "Update" button. Select it to set the change made.

    If we go back to the CAPC UI with the View displayed and refresh the page, a Blue Bar should be displayed at the top of each individual View just below the Title bar.



  • 3.  Re: RIB Query to list polling records of Interface Utilization

    Posted 11-04-2014 03:32 PM

    What changed in the  bulk data export?    We use that extensively.



  • 4.  Re: RIB Query to list polling records of Interface Utilization
    Best Answer

    Posted 11-06-2014 12:02 PM

    Hi Scott,

     

    This is the reference from the 2.3.4 October Update Kit fixed issues doc about what was done.

     

    • Symptom: Bulk Data Export Interface Component Element names are not uniquely identifiable
      Resolution: Bulk data export can now be configured to produce ifAlias and ifDescr in the CSV file. The easiest way to enable this is through the upgrade process as follows:- Stop the DA, this will cause any open CSV files to flush- Modify exportInfoResolverConfig by adding enableInterfaceOutput=true- Perform the upgrade install, this process will preserve the settings in exportInfoResolverConfig- Start the DA, start BDE and confirm that the CSV files contain the ifAlias and ifDescr columns at the right end of the columns
      (2.3.4_Oct_Update, 316409, 21855260-1)

     

    Thanks,

    Mike