Issue:
Whenever I export a flow to ALM, all the blocks are labeled as Step #, instead of the block name.
Steps to reproduce:
1. Create a Process Block and enter data into the name field.
2. Open General Config Click on ALM Click on design-step.
3. Map Step Name attribute to Block Name (Test Step) or Block Name (Extended by Output).
4. Save and Close config file.
5. Generate Stored Paths.
6. Export to ALM.
7. Look at test case in Test Plan.
You can see that Step Name = Step 1, Step 2 etc. regardless of data entered into the Block Name.
Environment:
CA Agile Requirements Designer (ARD)- Agile Designer
Cause:
This is a configuration issue.
To see the resolution to this issue, please visit https://comm.support.ca.com/kb/ard-block-name-does-not-export-to-alm-as-test-step-name/kb000072779