raw configure > set save_command_output = true
$\Nimsoft\probes\storage\hp_3par\data
look at the *_statvv_* file
Probe uses below columns to get utilization (if value is numeric):
Adm_Rsvd_MB, Adm_Used_MB, Snp_Rsvd_MB, Snp_Used_MB, Usr_Rsvd_MB, Usr_Used_MB
utilization = (used*100)/total;
Where total is sum of Adm_Rsvd_MB, Snp_Rsvd_MB and Usr_Rsvd_MB
and used is sum of Adm_Used_MB, Snp_Used_MB, Usr_Used_MB
------------------------------
Support Engineer
Broadcom
------------------------------
Original Message:
Sent: 01-10-2020 08:50 AM
From: Alex Yasuda
Subject: QOS_VIRTUAL_VOLUME_UTILIZATION - No Data
Are you able via CLI on HP see the value of The percentage of used capacity of the virtual volume?
Because if not, it will not show at the probe
------------------------------
Technical Support Engineer
Broadcom
Original Message:
Sent: 01-10-2020 12:00 AM
From: Rajesh S
Subject: QOS_VIRTUAL_VOLUME_UTILIZATION - No Data
Hi All,
We have CA UIM 9.02 and hp_3par 1.24 T6 probe deployed in robot for monitoring storage performance..
We are able to collect all QOS except "QOS_VIRTUAL_VOLUME_UTILIZATION" .. It shows blank report and at back end it is NULL value.
How to resolve this issue.