net_connect metrics issue

[Issac08]

Hi All,

 

 We have configured net_connect probe for TCP service monitoring ,each source with multiple destination IP's.

As a default net_connect will populate qos in destination servers.I tried the below work around to see all the service test metrics in Source IP itself ,but it is not working .Anyone faced the same issue?

 

• To display data on USM using the host IP address, create a key, is_devid_ip, in the probe Raw Configuration under Profiles node, Host section. Set the key value to yes and the probe creates DEV files based on the host IP address.

[Issac08]

Any suggestions on this?

[Phani Devulapalli]

Not sure setting is_devid_ip would solve your purpose here 

 

I guess the option which you are trying to set using is_devid_ip is similar to the one below 

 

[Issac08]

I tried this but it is not working .

[Phani Devulapalli]

Did you try Qos Source = Robot Address ?

[Issac08]

Yes Phani , i tried it was not working ,whether it is working for you ?

[Yu Ishitani]

Hello, Issac08.

I believe that you need to rebuild NIScache files in the robot with this change.

 

- Stop Robot

- Remove all files in NIScache folder

- Start Robot

 

Let me know how it goes.

Regards,

Yu Ishitani

[Issac08]

Still same issue ,not able to get the metrics in source .

[Phani Devulapalli]

Ok, just to have some clarity on your requirement....

 

Are you expecting to see all the targets listed under the source ? Like when you get to the metrics tab and expand you want to see all the destinations you configured listed under the Source metrics tab?

 

 

If this is the case, not sure this can be done 

[Issac08]

Phani Devulapalli wrote:

 

Ok, just to have some clarity on your requirement....

 

Are you expecting to see all the targets listed under the source ? Like when you get to the metrics tab and expand you want to see all the destinations you configured listed under the Source metrics tab?

 

 

If this is the case, not sure this can be done 

Yes Phani ,I am expecting the same ,want to see all the target under source, as a default it will work ,need to know by whether any custom method it is possible?

[Phani Devulapalli]

Ok, not sure it is possible that way out of the box 

 

Anyone can correct me if I am wrong 

[Yu Ishitani]

I don't think it is possible since it is required to set Robot name as QoS identification method which is currently not possible.

 

Regards,

Yu Ishitani