Hi all,
Not scripted e2e for a long time..
I'm getting into it again but noticed that when I hit record and click once on a log in box, e2e writes 3 sections of code:
UseWindow("MSTSC.EXE|RAIL_WINDOW",1)
ClickMouse(Left,Down,354,268)
UseWindow("MSTSC.EXE|IHWindowClass|Input Capture Window",1)
ClickMouse(Left,Down,620,482)
UseWindow("MSTSC.EXE|RAIL_WINDOW",1)
ClickMouse(Left,Up,354,268)
The conflicting "InArea" pixels are confusing me, which one is correct? I'm not sure why performing a single click in record mode is writing these 3 sections of code, surely there should only be one?
Any have any ideas why it's doing this? The code fails to click the log in box when I play the code back. No debug errors so the syntax is all ok.
Cheers,