Original Message:
Sent: Apr 26, 2023 09:56 AM
From: Atul Choudhary
Subject: Client subnet based source NAT doesn't work on Brocade ADX
@Jason McClellan I am not sure if customer has contract to open a case with Broadcom. Is there any alternate way to get community help or if there is any other community for Brocade ADX?
Original Message:
Sent: Apr 26, 2023 09:51 AM
From: Jason McClellan
Subject: Client subnet based source NAT doesn't work on Brocade ADX
@Atul Choudhary - we do not support Brocade questions on the Community. Please refer to Brocade Global Support (broadcom.com) Thank you Jason McClellan, Platform Admin
------------------------------
Thank you
Jason
Broadcom Community Platform Admin, IT
Original Message:
Sent: Apr 26, 2023 02:44 AM
From: Atul Choudhary
Subject: Client subnet based source NAT doesn't work on Brocade ADX
Hi All,
Can someone please help me to understand if I am doing anything wrong in Client subnet based source NAT configuration.
Below is the base config:
configure terminal
vlan 100 name VIP_VLAN
untag eth1
router-interface ve 10
exit
interface ve 10
ip address 192.168.200.1 255.255.255.0
exit
vlan 201 name REAL_VLAN
untag eth2
router-interface ve 20
exit
interface ve 20
ip address 192.168.201.100 255.255.255.0
exit
server real Web1 192.168.201.10
port http udp-only
exit
server real Web2 192.168.201.11
port http udp-only
exit
server virtual basicslb.com 192.168.200.2
port http udp-only
bind http Web1 http Web2 http
exit
To enable SNAT with specific IP, I have tried to add below options:
1. Below command doesn't do NAT at all.
server source-nat client-subnet 10.10.0.0 255.255.0.0 192.168.201.100
2. Below commands doens't do NAT at all:
server source-nat-ip 192.168.201.200 255.255.255.0 0.0.0.0 port-range 2
server source-nat client-subnet 10.10.0.0 255.255.0.0 192.168.201.200
3. If I enable "server source-nat" then it does NAT but not with 192.168.201.200 but SVI IP.
Any lead would be really helpful