Dear Team,
There are two additional teamings (failover order) for uplink 1 and uplink 2. Both have different active uplinks; this is specifying which uplink on the VDS the teaming policy should use.
After the uplink profile has been modified, the VLAN Transport Zone that is attached to the Edge Nodes must be modified or a new one created and attached to the Edge Nodes. This allows segments that are created and attached to this Transport Zone to utilize the named teaming policies.
an existing Transport Zone that is used specifically for Edge uplink segments being modified.
Segments that are created and attached to the Edge uplink Transport Zone can now utilize named teaming policies. below screen shows the configuration of a segment that will utilize a named teaming policy.
- The final step is to create an interface using the segment created Remember, using this segment ensures that traffic leaving this Tier-0 interface egresses the Edge Node on a specific uplink.
- When an uplink profile is applied to an Edge Node, the Edge uplinks are mapped to a VDS port group
Just wanted to know if same dvPGs flow the TEP and as well as VLAN traffic then what should be the teaming config on dvpg1 and dvpg2 would be ?
DVPG1
Vmnic1 (Active)
Vmnic2 (Active)
DVPG2
Vmnic1 (Active)
Vmnic2 (Active)
OR
DVPG1
VMnic1 (Active) and VMnic2 (Standby
DVPG2
VMnic2 (Active) and VMnic1 (Standby
OR
DVPG1
VMNic1 (Active)
DVPG2
VMNic2 (Active)