vCenter

 View Only
  • 1.  Port Group is not working.

    Posted Aug 16, 2022 01:37 PM

    Hello All,

    We have configured a virtual distributed switch with LACP and everything was working fine. But now we had a new requirement to add new Port Group. We did add a new port group to the VDS as well as on the Switch side(LACP) config. But the port group is not reachable.

    It's port group is working on the same host. Tested with 2 VM on the same host with same port group. But when I migrate one VM to another host and test connection between the VM's its not reachable. Verified all config on the switch side its fine as all the previously created port group are working. The VLANs and LACP config on the switch side are correct. Can anybody suggest me the troubleshooting steps on the VMware LACP side.

     

    Thank You.

     



  • 2.  RE: Port Group is not working.
    Best Answer

    Posted Aug 21, 2022 05:53 AM

    hi

    Go to Networking View Select the DVSwitch -> Configure -> Health check and click on “Edit“ > and Enable VLAN and MTU 

    you can insure that all VLAN pass to ALL Host or not.