ESXi

 View Only
  • 1.  Access USB on ESXi Host to transfer iso to DataStore

    Posted Nov 19, 2013 09:55 AM

    Hi All,

    I just got Dell Poweredge C1100.

    I was able to install ESXi 5.5 via USB as a boot device.

    Now I want to install some VMs but I have trouble since this server does not come with CDROM and has 100 Mbps NIC cards.

    I can connect the USB to guest VM and could access the device after Power On and Attach but that's not enough.

    (1) I would like to setup so the client VM the USB as a boot device so can start installing from USB.

    (2) The other option would be to transfer ISOs to datastore, but to do that over 100 Mbps NICs is a long process, I thought if I could access the USB on the host itself than I could quickly move ISO from USB to DataStore.

    Can you provide me directions as to how to accomplish either (1) or (2).

    Thanks!



  • 2.  RE: Access USB on ESXi Host to transfer iso to DataStore



  • 3.  RE: Access USB on ESXi Host to transfer iso to DataStore

    Posted Nov 19, 2013 05:55 PM

    Hi,

    Thanks for that tip. It could be life saver.

    I realize its valid only for FAT16, so my volume size could be 4GB max, but that should be enough for most ISOs'.

    Also I have ESXi 5.5, so hopefully it works.

    I will post some feedback after tonight since it's a home machine.

    Thanks again.



  • 4.  RE: Access USB on ESXi Host to transfer iso to DataStore

    Posted Feb 12, 2014 12:17 PM

    Hi vm4dp,

    I purchased the same server off ebay and am having difficulty getting ESXi 5.5 installed.  I have two different USB keys with ESXi 5.5 loaded and set the boot options properly in the BIOS but nothing works - it always goes to PXE boot and gets stuck.  It says "Missing Operating System".  Am I missing a step?



  • 5.  RE: Access USB on ESXi Host to transfer iso to DataStore

    Posted Feb 13, 2014 02:07 AM

    Hi,

    your C1100 should 2x Gbit NICs onboard and a seperate 100Mbit Management NIC. You can also boot a VM from an ISO image which is located on your local PC.

    Hope I got the question right!

    regards,

    Fred



  • 6.  RE: Access USB on ESXi Host to transfer iso to DataStore

    Posted Feb 18, 2014 05:11 PM
    Access USB on ESXi Host to transfer iso to DataStore follow these steps

    1) plug in USB drive in the ESX host whihc contained the ISO image.

    2) Go to the summary Tab of ESX host and select the datastore and browse.

    3) double click on the Image folder to open it and click the upload butten.

    4) select the USB drive from the source path and select the ISO image to upload.