06-04-2015 06:29 AM
Just a quick question:
We recently updated our BNA from 12.2.0 to 12.3.4 and since then we have a couple of messages like this one in our Masterlog every 60 minutes:
"Switch configuration upload on Discovery has no changes from the last saved Configuration"
Does anyone know where these messages come from or even better how to disable/configure them? I tried the Configuration Management, the Fabric Discovery and all helpfiles an the manual.
Any help is appreciated
06-15-2015 10:00 AM
This message is not from the switch and is generated by BNA, whenever the previously saved configuration is same as the current configuration on a switch.
You can create filters on your masterlog to filter out these messages if they are really annoying. (Should be covered under the MasterLog section of the help files)
There are 3 reasons why a configuration backup is triggered
1) Manual - User selects Backup now
2) Scheduled - Check the schedules that you might have created in the Configuration Backup dialog
3) Event triggered - If the switch send an event that requires a configuration backup to be triggered.
From the message you're seeing it has to be either 1 or 2 that is causing the configuration backup to be triggered.
Hope this helps.