The Water Cooler

  • 1.  Virtual Routing Interface

    Posted Mar 08, 2018 01:02 AM

    Receiving this error when trying to create virtual routing interface

     

    LPK-ICX6610-01(config)#
    LPK-ICX6610-01(config)#vlan 100
    LPK-ICX6610-01(config-vlan-100)#router-interface ve 100
    Invalid input -> router-interface ve 100
    Type ? for a list
    LPK-ICX6610-01(config-vlan-100)#

    ------------------------------------------------------------------------------------------------------------------------------------------------

    this is the output for show run

     

    LPK-ICX6610-01(config)#sh run
    running-config Current running-config
    LPK-ICX6610-01(config)#sh running-config
    Current configuration:
    !
    ver 08.0.10gT7f1
    !
    stack unit 1
    module 1 icx6610-24-port-management-module
    module 2 icx6610-qsfp-10-port-160g-module
    module 3 icx6610-8-port-10g-dual-mode-module
    stack-trunk 1/2/1 to 1/2/2
    stack-trunk 1/2/6 to 1/2/7
    stack-port 1/2/1 1/2/6
    stack enable
    !
    !
    !
    !
    vlan 1 name DEFAULT-VLAN by port
    !
    vlan 10 name LANUSER_GF by port
    tagged ethe 1/1/3
    !
    vlan 20 name LANUSER_1F by port
    !
    vlan 100 name WLAN by port
    tagged ethe 1/1/23 to 1/1/24
    untagged ethe 1/1/12
    !
    !
    !
    !
    hostname LPK-ICX6610-01
    no ip dhcp-client enable
    ip dhcp-server enable
    !
    ip dhcp-server pool vlan_100
    dhcp-default-router 192.168.100.254
    dns-server 1.9.1.9 8.8.8.8
    excluded-address 192.168.100.1 192.168.100.10
    lease 0 12 0
    network 192.168.100.0 255.255.255.0
    deploy
    !
    !
    !
    !
    !
    !
    !
    !
    !
    !
    !
    end

    LPK-ICX6610-01(config)#sh ver
    version System status
    LPK-ICX6610-01(config)#sh version
    Copyright (c) 1996-2014 Brocade Communications Systems, Inc. All rights reserved.
    UNIT 1: compiled on Dec 17 2014 at 18:25:28 labeled as FCXS08010g
    (7280225 bytes) from Primary /FCXS08010g.bin
    SW: Version 08.0.10gT7f1
    Boot-Monitor Image size = 370695, Version:10.1.00T7f5 (grz10100)
    HW: Stackable ICX6610-24
    ==========================================================================
    UNIT 1: SL 1: ICX6610-24 24-port Management Module
    Serial #: BXP3843N00B
    License: BASE_SOFT_PACKAGE (LID: dzrINJIpFFd)
    P-ENGINE 0: type E02B, rev 01
    ==========================================================================
    UNIT 1: SL 2: ICX6610-QSFP 10-port 160G Module
    ==========================================================================
    UNIT 1: SL 3: ICX6610-8-port Dual Mode(SFP/SFP+) Module
    ==========================================================================
    800 MHz Power PC processor 8544E (version 0021/0023) 400 MHz bus
    65536 KB flash memory
    512 MB DRAM
    STACKID 1 system uptime is 1 hours 54 minutes 55 seconds
    The system : started=cold start


    #TheWaterCooler


  • 2.  Re: Virtual Routing Interface

    Posted Mar 08, 2018 02:40 AM

    @2Y Comm

     

    due a acquisition by Ruckus , ICX Switches are not longer supported by Brocade.

     

    please post you question in they Community.


    #TheWaterCooler


  • 3.  Re: Virtual Routing Interface

    Community Manager
    Posted Mar 08, 2018 06:57 AM

    Thanks @Antonio Bongiorno

     

    @2Y Comm Please post your question over on the Ruckus ICX Forum Community.  They support the ICX.

     

     

    Thanks

     

    Jason

    Community Manager

    @jason_cmgr


    #TheWaterCooler