The Water Cooler

Back to discussions
Expand all | Collapse all

Command in vyatta 5400 to check if a specific flow has been allowed already?

  • 1.  Command in vyatta 5400 to check if a specific flow has been allowed already?

    Posted Apr 20, 2018 01:56 PM


    Hello all,

    I am looking for a command in Vyatta 5400 that allows me to check if a specific source and destination IP and port is being allowed by policies? In Juniper devices, the SRX firewalls have the command "show security match-policies from-zone XXXX to-zone XXX source-ip destination-ip destination-port" and other values you can add. It shows if a specific flow is allowed or not and also the policy name it hits. I have not found something similar in Vyatta yet. 

     


    Any help will be appreciated. 

     

    Post pulled from filter - moved to info and feedback @Jason McClellan

     


    #TheWaterCooler


  • 2.  Re: Command in vyatta 5400 to check if a specific flow has been allowed already?

    Community Manager
    Posted Apr 23, 2018 10:26 AM

    @Legacy User

     

    The product you are referring to was acquired by one of the companies listed on this information page.

     

    Please review >> https://community.brocade.com/t5/Info-Feedback/Brocade-Community-Forums-Redirects-to-Extreme-Networks-Pulse/m-p/94984/highlight/true#M194

     

    Best Regards,

     

    Jason M.
    Brocade Community Manager
    @jason_cmgr

     

     


    #TheWaterCooler