For more details, please see ourCookie Policy.


Fibre Channel (SAN)

Reply
Highlighted
Occasional Contributor
Posts: 18
Registered: ‎12-04-2017
Accepted Solution

ezswitchsetup

Good Morning, I recently configured a new 6510 switch using ezswitch. I got through the setup but when attempting to IE into the switch instead of opening up the Webtools initial switch interface it opens ezswitch dialog box where the new password should be entered. I cancelled out and retried but same results, I've even tried to change the password but it won't accept a new password. I can putty into the switch using the admin password and would be able to complete adding zones via putty but I would prefer to set the zones up using webtools. Thanks for your time.

Occasional Contributor
Posts: 18
Registered: ‎12-04-2017

Re: ezswitchsetup

Additionally I've uninstalled the ezswitch app and still the dialog box comes up.

Super Contributor
Posts: 321
Registered: ‎04-04-2018

Re: ezswitchsetup

Hello,

 

go to switch via ssh,

 

type configure

for webtools attributes type yes

press Enter untill you get: Basic User Enabled

 

 

If its Yes the EZswitch manager will be default instead of web gui.

 

Basic User Enabled (yes, y, no, n): [yes] y

 

If you will type NO. Web tools should launch nstead of  EZswitch manager 

 

Basic User Enabled (yes, y, no, n): [yes] No

 

Please mark this response as "Accept as Solution" if it answers your question.

Marian Bezeg
Occasional Contributor
Posts: 18
Registered: ‎12-04-2017

Re: ezswitchsetup

Thank You.

Join the Broadcom Support Community

Get quick and easy access to valuable resources across the Broadcom Community Network.