07-26-2018 07:23 AM
we have 2 fabrics, recently configured into a ring network via two DWDM ISP Paths. Check this thread.
Both Fabric A and B travel down 2 ISP paths between our DC and Edge office, but currently, data is only travelling down on path, as you can see from the attached BNA fabric topology graphic.
I've had a look through the historical logs and that's confirmed. Traffic did travel down the other path for a short period of time - couple of days, but now all travells down the the path you see in blue.
We're not maxing out the ISL bandwidth, occassionally we jump into yellow - between 40-80%, but not that often.
Is this the expected behavior for a ring topology? Would the alternative path light up if we push too much traffic down the live path?
The path that isn't currently used is the original path, so no configuration has changed on the two switches that make up that ISP ISL Trunk.
07-26-2018 08:38 AM
Thanks for the reply, I did think that, but the active path is 5km longer! Very peculiar.
If the ISL on the active path went over say 80%, would you expect the load to be balanced?
Should we just stick all Fabric A down one ISP path and Fabric B down the other? With no loop completed?
07-26-2018 09:59 AM
I think more clarity is needed.
In Fabric A
Red group = Ring
Blue group = Star
Black group = Line
Black to Red = Line
Black to Blue = Completes a ring
Where is your issue? The yellow and blue line connecting Blue and Red? If so, I don't see a ring, unless there is some additional connection to Fabric B.
Fabric B is similar, except that Red group is a Star, and Black group is a Star.
07-26-2018 02:26 PM