For more details, please see ourCookie Policy.

Fibre Channel (SAN)

Posts: 0

Is it possible to configure two ports point-to-point and not have wwn ?

I have a Brocade Silkworm 3250 with 2 ports connected. I want to see the devices on the host (a Solaris 9 system) with the device names assigned to them by the disk array (a 3510 e.g. c1t40d1) and not the WWN names the switch imposes. I've beed through the documentation but cannot find a way of doing this. Regards. Jim

Join the Broadcom Support Community

Get quick and easy access to valuable resources across the Broadcom Community Network.