04-01-2014 09:43 AM
And now the blade is in persistent disable mode and will not respond to anything.
I have tried
It comes up with the following error
Switch may be disabled, POD license is NOT installed, 7500E upgrade license is NOT installed, slot is off, port is persistently disabled or if this is VE port and associated GE is not in FCIP mode.
WT says port is Persistent Disable and both enable and disable are greyed out.
here is port cfg
portHealth: No Fabric Watch License
portDisableReason: Persistently disabled port
portFlags: 0x21 PRESENT DISABLED
POD Port: Port is licensed
portState: Persistently Disabled
port generation number: 224
portWwn of device(s) connected:
LE domain: 0
FC Fastwrite: OFF
Interrupts: 0 Link_failure: 0 Frjt: 0
Unknown: 0 Loss_of_sync: 0 Fbsy: 0
Lli: 0 Loss_of_sig: 0
Proc_rqrd: 0 Protocol_err: 0
Timed_out: 0 Invalid_word: 0
Rx_flushed: 0 Invalid_crc: 0
Tx_unavail: 0 Delim_err: 0
Free_buffer: 0 Address_err: 0
Overrun: 0 Lr_in: 0
Suspended: 0 Lr_out: 0
Parity_err: 0 Ols_in: 0
2_parity_err: 0 Ols_out: 0
Port part of other ADs: No
switch has a current fabric license
I tried to persistentenable in WT and it said Operation is not supported on this port.