Turn on suggestions
![]() Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
|
03-11-2012 10:35 AM
Hello
Found that the switch is continuosly rebooting, following error is seen
Resetting ATA controller.
ATA controller reset failed.
Read map file failedd
Resetting ATA controller.
ATA controller reset failed.
Read map file failedd
Resetting ATA controller.
ATA controller reset failed.
Retry reading the first kernel image
Resetting ATA controller.
ATA controller reset failed.
Retry reading the first kernel image
ATA()0xb9700's entry point is too small (0x00003DB8 < 0x00100000)
Booting "Fabric Operating System" image.
Resetting ATA controller.
ATA controller reset failed.
Read map file failedd
Resetting ATA controller.
ATA controller reset failed.
Read map file failedd
Resetting ATA controller.
ATA controller reset failed.
Retry reading the first kernel image
Resetting ATA controller.
ATA controller reset failed.
Retry reading the first kernel image
ATA()0x3c9bf's entry point is too small (0x00003DB8 < 0x00100000)
OSLoader contains no bootable devices.
The system is coming up, please wait...
Read board ID of 0x88 from addr 0x23
Read extended model ID of 0x1d from addr 0x22
Matched board/model ID to platform index 8
Read board ID of 0x88 from addr 0x23
Read extended model ID of 0x1d from addr 0x22
Matched board/model ID to platform index 11
Checking system RAM - press any key to stop test
Checking memory address: 00100000
System RAM test using Default POST RAM Test succeeded.
Press escape within 4 seconds to enter boot interface.
Booting "Fabric Operating System" image.
Resetting ATA controller.
ATA controller reset failed.
Read map file failedd
I did try to reload the switch from Secondary Partition. ..No-Go as the switch goes back to the same state.
Boot PROM password has not been set.
> printenv
AutoLoad=yes
ENET_MAC=00051E04FFF8
InitTest=MEM()
LoadIdentifiers=Fabric Operating System;Fabric Operating System
OSLoadOptions=quiet;quiet
OSLoader=ATA()0xb9700;ATA()0x3c9bf
OSRootPartition=hda2;hda1
SkipWatchdog=yes
> setenv OSRootPartition=hda1;hda2
> setenv OSLoader=ATA()0x3c9bf;ATA()0xb9700
> printenv
AutoLoad=yes
ENET_MAC=00051E04FFF8
InitTest=MEM()
LoadIdentifiers=Fabric Operating System;Fabric Operating System
OSLoadOptions=quiet;quiet
OSLoader=ATA()0x3c9bf;ATA()0xb9700
OSRootPartition=hda1;hda2
SkipWatchdog=yes
>saveenv
>auto
Noticed the OSLoader to have entry ATA() instead of MEM(). Why is it displaying ATA() instead of MEM()?
OSLoader=ATA()0x3c9bf;ATA()0xb9700
Has the CF gone bad?
Is switch replacement only possible solution or do we have any alternative?
Please advise
Thanks
Chetan R
03-11-2012 11:54 PM
If the switch is under mainatenance, i would open a call by Brocade.