Turn on suggestions
![]() Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
|
02-12-2013 09:47 AM
Is there a way to tell from the CLI or Webtools if a DCX -B Switch is running at 110V or 220V ?
Also is there a way to tell a Blade to power ratio on the DCX-B. Meaning how many power supplies or power is needed to run so many blades in the switch ?
I know there is a little information n the hardware guide but its very vague .
Thank you in advance .
02-12-2013 12:34 PM
hi, as far as i know, there's no way to tell what is the current PS voltage.
for the blade power consumption, use chassisshow command.
02-12-2013 01:05 PM
The PSU's are auto-sensing and auto-adjusting. If you refer to the FOS Release Notes, specifically the chapter entitled "Blade Support", it specifies the # of PSU's needed depending on your blade configuration and environmental power.
02-12-2013 01:20 PM
Thanks for the response
I believe Slotshow -p is a useful command as well.
Also the RN is the same info from the hardware guide
02-13-2013 09:34 AM
go to Power Calculator, and you get the exact answer you need.
http://www.brocade.com/data-center-best-practices/competitive-information/power.page