07-25-2018 02:45 AM
I am trying to establish a new link between 6510 Switches. Both of them are using identical 16G SR SFPs (HP QK724A). One is running FOS 7.4.1b and the other FOS 7.4.2c and both show the port in question as an Online D-Port. However,
fcsw-dus-b3:admin> portdporttest --show 22
Remote WWNN: 10:00:c4:f5:7c:2f:f9:94
Remote port index: 8
No. of test frames: 1 Million
Test frame size: 1024 Bytes
FEC (enabled/option/active): Yes/No/No
CR (enabled/option/active): Yes/No/No
Start time: Wed Jul 25 11:28:24 2018
End time: -------------------
Status: NOT STARTED
Test Start time Result EST(HH:MM:SS) Comments
Electrical loopback -------- NOT STARTED -------- ----------
Optical loopback -------- NOT STARTED -------- ----------
Link traffic test -------- NOT STARTED -------- ----------
Roundtrip link latency: unknown
Egress power: Tx: -2.5 dBm, Rx: Not Avail.
Ingress power: Rx: -2.2 dBm, Tx: Not Avail.
It stays in this state, manual prodding with portdporttest --start doesn't help either. How do I run the D-Port test?
07-26-2018 05:46 AM
i had a customer with a similarly issue, here try the customer to start d_port test in a ISL / Trunk, and the test return Failed.
1) is in you case a ISL/Trunk ?
2) are the Port on both site correct configured ?
3) what type of cable is in use OM3 or OM4 ?
4) did you try to run the command as admin or as root ?
07-26-2018 05:53 AM
07-26-2018 06:01 AM
can you please change the speed level a fixed on both side ?
you should do that with port disable, however I don't know if this is productive
07-26-2018 06:09 AM
sdiff shows some differences, not sure, but maybe there's something important that should match?
fcsw-dus-b3:admin> portcfgshow 22 | fcsw-bb-b2:FID128:admin> portcfgshow 8 Area Number: 22 | Area Number: 8 Octet Speed Combo: 1(16G|8G|4G|2G) Octet Speed Combo: 1(16G|8G|4G|2G) Speed Level: AUTO(SW) Speed Level: AUTO(SW) AL_PA Offset 13: OFF AL_PA Offset 13: OFF Trunk Port ON Trunk Port ON Long Distance OFF Long Distance OFF VC Link Init OFF VC Link Init OFF Locked L_Port OFF Locked L_Port OFF Locked G_Port ON | Locked G_Port OFF Disabled E_Port ON | Disabled E_Port OFF Locked E_Port OFF Locked E_Port OFF ISL R_RDY Mode OFF ISL R_RDY Mode OFF RSCN Suppressed OFF RSCN Suppressed OFF Persistent Disable OFF Persistent Disable OFF LOS TOV mode 0(OFF) LOS TOV mode 0(OFF) NPIV capability ON NPIV capability ON QOS Port OFF | QOS Port AE Port Auto Disable: OFF Port Auto Disable: OFF Rate Limit OFF Rate Limit OFF EX Port OFF EX Port OFF Mirror Port OFF Mirror Port OFF SIM Port OFF SIM Port OFF Credit Recovery ON Credit Recovery ON F_Port Buffers OFF F_Port Buffers OFF E_Port Credits OFF E_Port Credits OFF Fault Delay: 0(R_A_TOV) Fault Delay: 0(R_A_TOV) NPIV PP Limit: 126 | NPIV PP Limit: 255 NPIV FLOGI Logout: OFF NPIV FLOGI Logout: OFF CSCTL mode: OFF CSCTL mode: OFF TDZ mode: OFF TDZ mode: OFF D-Port mode: ON D-Port mode: ON D-Port over DWDM: OFF D-Port over DWDM: OFF Compression: OFF Compression: OFF Encryption: OFF Encryption: OFF FEC: ON FEC: ON FEC via TTS: OFF FEC via TTS: OFF Non-DFE: OFF | 8G Non-DFE: OFF(Auto)