03-24-2015 09:49 AM - edited 03-24-2015 09:55 AM
We are moving from MDS switches to Brocade 6505 as part of a new SAN implementation. We currently have portchannels configured from our MDS to the UCS boxes. Is there a way to create aggregated links from the Brocade to the UCS? I know port channel is proprietary to Cisco, but we're looking for something at least similar.
Also if there is any documentation to support any information provided, it would be much appreciated. Most of the docs I find are from 2013 or older.
Solved! Go to Solution.
03-24-2015 01:13 PM
is all very simple.
see attached DOC for you reference, and follow this instruction.
The main configuration settings you need to pay attention to are:
1 NPIV mode must be enabled on the Brocade FC ports where you connect the uplinks from UCS (FabricInterconnect or NX5k)
a.Per default NPIV is enabled on all ports ..but check in case customer has changed that
2 On Condor 2 you must set the fill-word manually [to mode 2, -idle-arbff]
a.–on the Condor 3 fillword command is decrapted
3 You must decide how you will configure the VSAN configuration ..either pinning ….or most likely create VSAN A (to Brcd Fabric A) & VSAN B (to Brcd Fabric B)
4 Finally ..of course you must create the zoning in the brocade Fabrics.
This all are described in detail in the doc.
03-25-2015 05:40 AM - edited 03-25-2015 05:46 AM
Thank you for the reply, much appreciated.
Will this configuration provide with the same bandwidth and redundance as a native MDS-->UCS portchannel would?
03-25-2015 05:48 AM
I mean in a port channel you end up with aggregated bandwith increase because you tie together mulitple physical ports into a logical one. Does the Brocade provide similar or same functionality with this sort of configuration?