Boot switch after - erase all FLASH

[Anonymous]

Hi,

I have switch  "HP B-series 8/24c SAN Switch BladeSystem c-Class" after erase all FLASH. I want load FLASH over xmodem in HPBC. DO you know write steps do it?

Best regards

[Antonio Bongiorno T…]

No way here. Ask by Cisco.

C-Class Switches are Cisco Switches, and not Brocade.

however is note you wrote: "B-series" but not change the situation.

You cannot format and reload the CF, in Brocade is this not available.

Message was edited:

[Anonymous]

It's BROCADE switch :

3. Fibre Channel

        Product Name: HP B-series 8/24c SAN Switch BladeSystem c-Class

        Width: Single

          ...

        Manufacturer: BROCADE

[Antonio Bongiorno T…]

I edited my preview post, as mentioned you cannot reload the FOS on Brocade Switches.

[Anonymous]

Ok, but I used standard Brocade command from Brocade console shell:

erase all FLASH

I think Brocade must have way for resolving the situation!

[Antonio Bongiorno T…]

This is a Maintenance feature

From Brocade is a Tool available called INET Image, but only available with Active Maintenance Contract.

I post this info at several time here in the community.

[Anonymous]

Yes, I saw it. I have big fabric ~50 switches, Brocade support for big and HP support for BC switches. If I understand wright, I need net_install.img file for download it to switch over xmodem. Relay strange then Brocade give erase command, but not way for resolving problem. 

[Antonio Bongiorno T…]

Andrew,

--->>> I have big fabric ~50 switches,

you can have a Fabric with 1000+ Switches and this One = 1001,

and if this One is under maintenance, then you can open a call by Brocade or they OEM Supplier in such case HP.

[Anonymous]

I oped case in HP but, search faster way over vendor.

Anyway, thank you about your replay.

Best regards

Andrew