04-15-2016 10:01 AM
have you tried anothe min / max commit rate ?
>5000000 / 9500000 kbps
min 4000000 / max 9000000
keep in mind, both side must have the same value, additional i would first stop the circuit before re-configure and then bring up
04-15-2016 11:52 AM
I've tried with multiple combination varing from 1G - 10G, where the min was 4x, 2x or 1x of the max.
The fastes combination I can get operational is 1/2. 2/2 fails, for instance
04-19-2016 09:36 PM
If the tunnel/circuits fails there should be an event message outlining the issue why it dropped the link. If there are inconsistencies between the two end-points from a configuration perspective a circuit will not come up.
04-20-2016 08:00 AM
Perhaps I'm looking in the wrong place for the event message. Where would you look for it?
A new note, as part of the troubleshooting:
Setting the min/max to 2G/3G leaves the tunnel/circuit "up", but it fails to pass any traffic...
04-20-2016 05:32 PM
I assume you have warranty and/or maintenance on these boxes. I would open a ticket with your vendor and capture a supportsave from both of them to have it looked at. There are a few areas where this can go wrong. It's simply too hard to speculate on this.