05-30-2016 12:48 PM
->Switch and my question is i upload the router ?
i think you have loaded the Router Code
ip route command, is not available on ADX with Router Code.
the command can executed on switch code only.
for this reason you get back "Unrecognized command"
05-30-2016 12:58 PM
No, i don't say you need to upload the Route Code.
ip route command is available on switch code only.
can you please post the entire output from command
05-30-2016 01:04 PM
if switch code is loaded,
i note follow in you post:
->SSH@GDA-ADX-PORTAL-B#show ip route
you must lauch the command as mentioned yesterday in my other post from #config level, in example
#config-if-mgmt-1)# ip route
05-30-2016 01:05 PM
Copyright (c) 1996-2009 Brocade Communications Systems, Inc.
Boot Version 12.5.00T405 Aug 14 2012 11:09:42 PDT label: dob12500
Monitor Version 12.5.00T405 Aug 14 2012 11:09:42 PDT label: dob12500
System Version 12.5.02fT401 Dec 30 2015 19:09:34 PST label: ASM12502f
AXP Version: 2.01 Dated: 2013/02/28 15:13:07
PAX Version: 8.7 Dated: 2012/02/28 17:04:52
MBRIDGE Version: 000b, Device ID # bebe
Type: ServerIron ADX 1016-4-PREM
Backplane Serial #: E20512G5KW
Chassis Serial #: E30542G00A
LID #: gIFKJHiFFc License: SI-1016-4-SSL-PREM
Part #: 35723-002
SSL Card - Serial #: 1F0508G14P Part #: 40-1000373-02
Version #: 13b626-05050505-111d8036-00
Active management module:
1499 MHz Power PC processor (SVR 2.1, PVR 8021/0030) 599 MHz bus
512 KB Boot flash
131072 KB Code flash
2048 MB DRAM
The system uptime is 4 days 14 hours 53 minutes 1 seconds
The system started at 23:11:58, GMT-06, Wed May 25 2016
05-30-2016 01:12 PM
Configuring an IP route over the management port
You can configure up to 32 static routes over the management port. On switch code, in order to
configure an IP static route on the management port with a destination address of 10.0.0.0
255.0.0.0 and a next-hop router IP address of 10.1.1.1, enter the following commands.
ServerIronADX(config)#interface management 1
ServerIronADX(config-if-mgmt-1)#ip route 10.0.0.0 255.0.0.0 10.1.1.1
05-30-2016 01:16 PM
You are NOT on Router Code, you are in switch code, so the command is not working.
On router code, in order to configure an IP static route on the management port with a destination
address of 10.0.0.0 255.0.0.0 and a next-hop router IP address of 10.1.1.1, enter the following
ServerIronADX(config)#ip route 10.0.0.0 255.0.0.0 10.1.1.1