Management Center and Reporting

 View Only
  • 1.  Reset 'enable mode' Password for MC CLI

    Posted Mar 30, 2021 08:51 AM
    Hi,

    I am able to login to the management center using CLI, but when I try to enter enable mode it says "bad password". How to reset the enable mode password?

    regards,
    sohail


  • 2.  RE: Reset 'enable mode' Password for MC CLI

    Broadcom Employee
    Posted Mar 31, 2021 04:36 PM
    Hi Sohail,

    You will need to access the serial console or host console (if VA) to perform this. If you've ever reset the enable password on ProxySG from the serial console, it is the same way. From the serial console, go through the setup wizard:

    Press "2) Setup Console"
    It will then ask you what interface to configure. All the defaults should load, and so you can simply hit enter through this section.


    The next section will ask about passwords. When it asks about changing the enable password, select yes.


    Enter and verify your new enable password.

    Proceed with the rest of the setup wizard. The only thing that should change is any configurations that you changed in the setup wizard.

    Hope that helps.