This section documents how to upgrade from release 12.6 to 14.0 without an IPL.
Note: If you have installed any of the CA TLMS Tape Library Management System z/OS usermods from a previous release, you can continue to use them until the next scheduled IPL, then we recommend that you put in the 14.0 usermods. These usermods include the Failsafe usermod, IGXMSGEX, and the OAM exits (CBRXUENT, CBRUXEJC, CBRUXVNL) if they were installed using the CTSJUCBX usermod. If the CTSJUCBR usermod is used on the z/OS CSI (which simply renames the IBM default exits), then no change is needed for the OAM exits.
Follow these steps:
Back up the 12.6 load library.
Restore the 12.6 OSI intercept table.
Product(CA TLMS) VERSION(TLC6) INIT(TLC6INIT) - PARM(REINIT,OSI=NO)LOADLIB(hlq.TLMS.r126.CTAPLINK)
Product(CA TLMS) VERSION(TLC6) INIT(TLC6INIT) -
PARM(REINIT,OSI=NO)
LOADLIB(hlq.TLMS.r126.CTAPLINK)
Load 14.0 dynamically by executing the CAS9 procedure with the following control statements for CA TLMS in CARIMPRM:
PRODUCT(CA TLMS) VERSION(TLE0) INIT(TLE0INIT) -PARM(REINIT,LPA=ALL) -LOADLIB(hlq.TLMS.r14.CTAPLINK) PRODUCT(CA TLMS) VERSION(TLE0) INIT(TLE0INIT) -PARM(REINIT,OSI=YES) -LOADLIB(hlq.TLMS.r14.CTAPLINK)
PRODUCT(CA TLMS) VERSION(TLE0) INIT(TLE0INIT) -PARM(REINIT,LPA=ALL) -LOADLIB(hlq.TLMS.r14.CTAPLINK)
PRODUCT(CA TLMS) VERSION(TLE0) INIT(TLE0INIT) -PARM(REINIT,OSI=YES) -LOADLIB(hlq.TLMS.r14.CTAPLINK)
Start CTS if previously active using the r14.0 CA TLMS libraries.