SYSVIEW Performance Management

 View Only

  • 1.  COMMAND VSAM

    Posted Aug 29, 2019 03:34 PM
      |   view attached
    When I use the VSAM command, it does not bring me any information. Would someone know why?

    ------------------------------
    Especialista
    CTIS INFORMTICA LTDA
    ------------------------------


  • 2.  RE: COMMAND VSAM
    Best Answer

    Broadcom Employee
    Posted Aug 29, 2019 03:44 PM
    Francisco,

    The VSAM command will display statistics for OPEN VSAM data sets in the current target address space.
    I will assume that your current target address space (C007066) should have VSAM data sets.
    To further check this, you can issue the DSALLOC command for the target address space.
    Then issue the SELECT command to show only those data sets that have an org of VSAM.

    Commands:
    DSALLOC
    SELECT ORG EQ VS

    Look at the "Open" column to determine if the data set is currently open.







    ------------------------------
    Todd J. Gagle
    Architect of Software Engineering, Team SYSVIEW
    Broadcom
    ------------------------------

    Original Message