Migrate 13.0 to 13.5 question

[Makn]

Hello,

I was reviewing the two migration steps for the SSMGAV2. We don't use it at all. Do any of these steps need to be completed?

The systems are configured as SSMPLEX=NONE.

Step one says to copy a few rules, including SSMBEGIN and enable/autoenable them. The only rule we currently have enabled is SSMBEGIN.
Must those other rules be copied/enabled/autoenabled?

Step Two says to run OPGAV2CV. There are no moveable resources or cross system reqs in our configurations.
Do we need to do this step?
And finally for Step Two. If in the future there was a need for cross system reqs, would they work even if OPGAV2CV hasn't been run?

Thanks,
Mark

[Carlos Filho]

Hello Mark,

If you don't use SSMGAV2 you don't need to be concerned about those migration steps. Even if in the future you need to implement cross-systems pre-reqs.

Regards,

Mario

------------------------------
Carlos Mario Silveira Filho
Principal Support Engineer
[e-mail]
Broadcom


------------------------------