OPS/MVS

 View Only

  • 1.  OPSLOG Archive after OPSLOG switch

    Posted May 25, 2018 08:42 AM

    Hi,

     

    I would like to trigger the OPSLOG archive program whenever there is an OPSLOG switch (message OPS4626O).

    How do I know how many tracks I need to specify in the parameters?

     

    Thanks for the info.

    Guy



  • 2.  Re: OPSLOG Archive after OPSLOG switch

    Broadcom Employee
    Posted May 25, 2018 04:43 PM

    Hello,

     

    Thank you for posting this question. I will have someone provide you with some feedback early next week, unless someone responds beforehand.

     

    Regards,

    Frank Ingarra

    CA



  • 3.  Re: OPSLOG Archive after OPSLOG switch
    Best Answer

    Broadcom Employee
    Posted May 29, 2018 12:12 PM

    Hi Guy,

     

    The DASD space allocations that you set up with the Application Parameter Manager for your OPSLOG archiving will be used.  These allocations will be overly sufficient as a final archive will always be at least equal to or smaller than a 'normally scheduled' archive. The OPSLOG archive procedure will also release any initially allocated space that was not used. 

    If you are using the 'new' OPSLOG Archive method, all space calculations are determined by OPS/MVS when initiating the archive, including the automatic initiation of a 'final' archive. 

     

    Regards,

    Tyrone Lastoria

    CA