OPS/MVS

Expand all | Collapse all

Hi All,

Jump to Best Answer
  • 1.  Hi All,

    Posted 01-18-2018 09:49 AM

    I need to change the Color of a multi line message in Opslog from white to Green . The filter criteria of that message is in 2nd line , so   MSG.COLOUR is changing the color of only one line in the message instead of entire line.

    Could you please advise on this.

     Thanks in advance



  • 2.  Re: Hi All,
    Best Answer

    Broadcom Employee
    Posted 01-22-2018 12:30 PM

    Hello Manju,

     

    Here is a possible solution that will use 2 message rules.

    1) A MLWTO rule that will intercept the original message:

    )MSG xxxxxxx MLWTO
    )PROC
    DO I = 1 TO MSG.TEXT.0
    MSGSAV.I = MSG.TEXT.I
    /* HERE COMES THE FILTER YOU WANT */
    IF POS('***',MSG.TEXT.I) > 0 THEN REISSUEMSG = 'YES'
    END
    IF REISSUEMSG = 'YES' THEN
    ADDRESS WTO "TEXTVAR("MSGSAV.") MSGID(NEWMSGID)"  

    The above rule you save each line of the original message and reissue the message as WTO in case it finds the text that matches your filter. Notice that the WTO must be issued under a different message id.

    2) The second rule will intercept the new message and change the collor of all lines:

     

    )MSG NEWMSGID
    )PROC
    MSG.COLOR = OPSCOLOR('TURQ')

     

    Regards,

    Mario

    Carlos Mario Filho
    Principal Support Engineer
    CA Technologies