Component info of uni* commands

[P Verghese]

Dear All,

I am trying to figure out where the component list that is used by uni* command stored?

We have a shadow scheduler server and the unifstat gives the following output:

CA Services Status Report

Component Name Pid Status
------------------------------------ ------- --------------
WAAE Web Server (LAB) 1907 running
WAAE Agent (waaesvr91_LAB) 1438 running
WAAE Scheduler (LAB) - not active
WAAE Application Server (LAB) - not active

But in reality both the app server as well as sched are running.

waadm@waaesvr91 ~]$ autosyslog -e


Monitoring shadow event schedular output file:
/opt/CA/WAAE/autouser.LAB/out/event_demon.shadow.LAB

*** To break out type control-c (^c) ***

[01/25/2023 17:28:01] ----------------------------------------
[01/25/2023 17:30:00] ----------------------------------------
[01/25/2023 17:31:00] ----------------------------------------
[01/25/2023 17:32:00] ----------------------------------------

Not sure if the result of unifstat is correct on a shadow server.

Any thoughts?

Regards
P Verghese

[Jose Lopez]

Hi,

as far as I know unifstat should work on a shadow server.

and the config files.in directory..../SharedComponents/csutils/config

hope it helps.

José

[P Verghese]

Hi Jose,

The output of unifstat is incorrect on shadow server. Even though both app and sched are running it shows them as not running.

Also when we start these components on shadow the result shows them as failed. 

unicntrl start waae_server.LAB
WAAE Application Server (LAB) FAILED.
Executed waae_server.LAB start...................................FAIL 1

unicntrl start waae_sched.LAB
WAAE Scheduler (LAB) Scheduler started.
FAILED.
Executed waae_sched.LAB start....................................FAIL 1

But they do start and run. So this is confusing and not sure what is happening.

Regards

P Verghese