DX Unified Infrastructure Management

 View Only
  • 1.  Modifying threshold of a specfic service in ntservices probe.

    Posted Nov 20, 2019 04:50 PM
    Is there a way to modify the alert threshhold of a certain Microsoft Service?

    Currently ntservice probe is configured this timers:
    initial_delay 120
    interval 300
    timeout 100

    I don't want to change the probes's configuration but instead, what I wanted to achieve is to set a certain Application Service (under ntservice probe> Raw Configure> services) to send an alert after 15 minutes that it is down.


  • 2.  RE: Modifying threshold of a specfic service in ntservices probe.
    Best Answer

    Posted Nov 20, 2019 06:14 PM
    An AO rule would work for you, set your ntservices profile to informational, and get the AO rule to create a new alarm after 15 minutes.

    This assumes your informational alerts are used for a logic play ground.  Informational alerts are not visible to my users, it's my logic play ground.  

    Or, use the Admin Console and use Time over Threshold, if the probe is supported in there.  I'm guessing it is.

    ------------------------------
    CA - UIM administrator
    ------------------------------