For the edification of others, the About System (versions) option in the Configure System Settings section of the ssgconfig menu lists the RPMs on the Gateway, which *should* include the CR for the ssg:
CA Technologies Software Versions
- ssg-appliance-9.2.00-9087_CR10_x86_64
- ssg-nshieldpci-8.0-12.10.el6_x86_64
- ssg-platform-1.6.00-97_noarch
- ssg-9.2.00-9087_CR10_noarch
- ssem-1.17.00-6799_noarch
Press [Enter] to continue
------------------------------
Jay MacDonald - Adoption Architect - Broadcom API Management (Layer 7)
------------------------------
Original Message:
Sent: 03-30-2020 05:02 PM
From: Reed
Subject: Current Platform Level ??
This is no longer required. I found you could install CR4 over any current v9.4 installation so it didn't matter where I was sitting. Thanks.
Original Message:
Sent: 03-30-2020 10:38 AM
From: Reed
Subject: Current Platform Level ??
Hello. Our Security department is flagging our API Gateway as being out of compliance because of the Java version in use (1.8.0_181). We are required to get to either 1.8.0_241 or Java 11.0.6.
I see some articles that v9.4-CR3 has resolved this issue.
My question is how do I check to see which CR or Platform level I am current running so that I can properly chart an upgrade path for my servers?
Patch menu shows no patches.
The About menu shows:
ssg-9.4.00-8872_noarch
ssg-platform-1.8.00-346_noarch
ssg-appliance-9.4.00-8872_x86_64