Yes, You are right.
Here is the screen show in Windows ODBC64 Data Source.
When click "Finish" button, it will show Oracle DB connection info., which is used to connect Oracle User Store.
Original Message:
Sent: 07-06-2020 03:19 AM
From: Akio UCHIDA
Subject: Oracle Wire Protocol driver
Hello,
Thanks for your reply.
After installing Oracle Wire protocol driver in the policy servers, I'm guessing users have to configure it.
On the manual, how to configure it only for UNIX system is described.
< Configure the Oracle Wire Protocol Driver>
So, I cannot understand whether there are any steps for Windows servers.
< Configure an Oracle Data Source >
→ I think this procedures are to be done on user directory.
Am I right?
Regards,
UCHIDA Akio
Original Message:
Sent: 07-06-2020 01:41 AM
From: Bong-Kyun Rhim
Subject: Oracle Wire Protocol driver
Hi UCHIDA
Oracle Wire protocol driver is installed during the policy server installation on windows.
Regarding Oracle Write protocol configuration for user directory, please see the following page.
https://techdocs.broadcom.com/content/broadcom/techdocs/us/en/ca-enterprise-software/layer7-identity-and-access-management/single-sign-on/12-8/configuring/policy-server-configuration/user-directories/configure-an-odbc-user-directory-connection.html#concept.dita_89466b4a5fecc38706c0dd3a507817602440bd83_ConfigureanOracleDataSource
Kind regards
B.K.
Original Message:
Sent: 07-05-2020 09:50 PM
From: Akio UCHIDA
Subject: Oracle Wire Protocol driver
Hello,
I'd ask how to configure Oracle Wire Protocol driver for Windows server.
An user will user oracle DB for the user directory.
Looking through this page, I understood they had to follow the described procedures.
https://techdocs.broadcom.com/content/broadcom/techdocs/us/en/ca-enterprise-software/layer7-identity-and-access-management/single-sign-on/12-8/configuring/policy-server-configuration/user-directories/configure-an-odbc-user-directory-connection.html#concept.dita_89466b4a5fecc38706c0dd3a507817602440bd83_EstablishtheODBCUserDirectoryConnection
・Configure the Oracle Wire Protocol Driver
But if they use Windows server for the policy server, are there any procedures to configure Oracle Wire Protocol driver?
Regards,
UCHIDA Akio