DX Unified Infrastructure Management

  • Private Community
 View Only

  • 1.  CDM Probe - Timeout in disks (non-windows platform)

    Posted Aug 21, 2019 05:46 AM
    Hi,

    In the CDM Probe, under Setup - Control properties - Disk properties, what does "Timeout" mean?  I look it up in the CDM probe manual, but it was not clear.  Anyone can shed some light on this?





  • 2.  RE: CDM Probe - Timeout in disks (non-windows platform)
    Best Answer

    Broadcom Employee
    Posted Aug 21, 2019 08:13 AM
    Hi Naronkij,

    The explanation is further down on that page.

    https://docops.ca.com/ca-unified-infrastructure-management-probes/ga/en/alphabetical-probe-articles/cdm-cpu-disk-memory-performance-monitoring/cdm-im-configuration

    (Non-Windows platforms only) Timeout: specifies the maximum time for the probe to collect monitoring information. For example, timeout for disk fail or crash scenarios in stale filesystems allow you to prevent the probe from going into a pending state. You can specify the default timeout of 5 seconds to retrieve the disk statistics.

    Best Regards,
    Steve

    ------------------------------
    [Designation]
    [City]
    ------------------------------

    Original Message


  • 3.  RE: CDM Probe - Timeout in disks (non-windows platform)

    Posted Aug 23, 2019 05:31 AM
    Hi Steve,

    Thanks for the clarification.

    Regards,
    Narongkij
    Original Message