copy of message sent to me:
The documentation pointed out has already been consulted and applied; Where we are using the IP ADDRESS of the server hosting the Web page to receive the alarm next to the CA SPECTRUM.
However the best solution for us the alarm is received together with the same referenced in the SPM TEST.
Change the name of the profile in url_response to match what you want as the source and then use the previously referenced setting at the Advanced tab, or provide details which will enable more meaningful guidance.
------------------------------
Support Engineer
Broadcom
------------------------------
Original Message:
Sent: 06-25-2019 04:55 PM
From: DAVID MICHEL
Subject: URL_RESPONSE ALARMS
If the question is on using the url_response source override to use the url, that is documented here:
https://docops.ca.com/ca-unified-infrastructure-management-probes/ga/en/alphabetical-probe-articles/url_response-url-endpoint-response-monitoring/url_response-im-configuration
Navigate to the Advanced tab to override the source of Alarm and QoS messages. If you do not enter a value in Source override field for Source used for Quality of Service, the robotname of system where probe is deployed is the QoS source.
The following variables can be used in these fields:
$url: If $url is specified in Source override field, then $url is replaced by url of URL server in source fields of Alarms and QoS.
------------------------------
Support Engineer
Broadcom
Original Message:
Sent: 06-25-2019 01:55 PM
From: Cassio Pinheiro
Subject: URL_RESPONSE ALARMS
Alex, the question was asked in this group, because it is the UIM that points the target device through the field "Source Override".
But I'm going to write a question there as well.
Cássio Pinheiro - GPD
PRODEMGE
------------------------------
Analista
Cia de Tecnologia da Informação de Minas Gerais - PRODEMGE
Original Message:
Sent: 06-25-2019 01:33 PM
From: Alex Yasuda
Subject: URL_RESPONSE ALARMS
Please open this Question at this other community to see if someone from Spectrum Team can help:
https://community.broadcom.com/enterprisesoftware/communities/community-home/digestviewer?CommunityKey=671164c3-e575-4b08-96ab-edc2e1ceed13
------------------------------
Senior Support Engineer
Broadcom
Original Message:
Sent: 06-25-2019 10:50 AM
From: Cassio Pinheiro
Subject: URL_RESPONSE ALARMS
How to publish url_response alarms in the CA SPECTRUM SPM TEST module. We need to generate the UIM monitoring alarm on the corresponding DEVICE URL, in the SPM TEST module of the CA SPECTRUM tool.
------------------------------
Cássio Pinheiro - GPD
Cia de Tecnologia da Informação de Minas Gerais - PRODEMGE
------------------------------