Service Virtualization

 View Only
Expand all | Collapse all

TEST SUITE ran from LISA Invoke in LISA 7.5.2 always shows pass count =1? Why so

  • 1.  TEST SUITE ran from LISA Invoke in LISA 7.5.2 always shows pass count =1? Why so

    Posted Feb 24, 2016 06:14 AM

    I tried running a test suite having 2 test cases within it through Lisa Invoke and the xml response we get on IE always states

    <passcount>=1

    <failcount>=0

    <warningcount>1

    <errorcount>1

     

    If i have 2 test cases running in a suite, y it has passcount as 1 and not 2.

     

    Even when i am having one test case as successfull test case, other having error. passcount is always 1 but ideally it should show passs count as 1 and fail count as 1 in lisa invoke. Kindly let me know your thoughts



  • 2.  Re: TEST SUITE ran from LISA Invoke in LISA 7.5.2 always shows pass count =1? Why so

    Broadcom Employee
    Posted Feb 25, 2016 08:17 PM

    Is your test iterating through its own data, or is it allowing its staging document to do the iteration?

     

    If the test is iterating, I would expect a report to say that it has completed once (I'm not sure about pass/fail status - if the test fails during an iteration but is set to continue on error, it might reset the pass/fail state when it next reaches that assertion?). If the iteration is done by the staging document, I would assume the report would count each iteration.



  • 3.  Re: TEST SUITE ran from LISA Invoke in LISA 7.5.2 always shows pass count =1? Why so

    Posted Feb 27, 2016 05:49 AM

    Its working fine now.....seems like some issue was there.