In TDM 4.5, two generators are set-up under different projects (say A & B). The publish of each generator is successful (from Portal) using their respective default configuration. This is true even when published through respective self-service flow. However when both the generators are part of a single self-service flow (created using ARD 2.8), the publish fails with below error message.
Error Message: "Exception occured in default configurations: TDMException: Failed to load default configuration.: TDMException: Http Exception in TDM Generator service, Error : 400 Bad Request"
Is it technically possible that a self-service flow (created using ARD 2.8) can have two process blocks linked to generators of two different TDM Projects?
Is it technically possible that a self-service flow (created using ARD 2.8) can have two process blocks linked to generators of two different TDM Projects?--- Yes, I believe that is possible.
However to further investigate this case, could you run the task in Debug mode of the Portal and check the logs if you find anything.
Please find the link below to run Portal in Debug mode.
TDM Portal: How to enable debugging for TDM Portal - CA Knowledge
Please share the results with us.
Sr. Support Engineer