Maybe the
portal where the information on supported metrics and vendor certifications could help you realize what each parameter is and how its computed.
Whenever I have doubts, I use this portal and if I cannot find what I need I check it under Metric Families and Vendor Certifications pages on the DA administration.
If that doesn't answer your question either, you always have the options to enable debug on the DC to check how the values are extracted from the monitored devices and pushed into the DB. This is also the procedure I'm using to create custom vendor certifications or custom metrics.
------------------------------
Senior Consultant
SolvIT Networks
------------------------------
Original Message:
Sent: 02-12-2020 12:52 PM
From: Bruno Sousa
Subject: BPS In vs Bits In Total Rate KPIs in DX PM
Hello
Have some discussion regarding the values of graphics with these 2 network KPIs, but I think is a matter of bad interpretation.
Can you please help me with the interpretation / meaning of these 2 KPIs?
Bits per second In vs Bits In Total Rate?
Do you have any link / documentation on the subject?
Thank you in advance.
Best regards
Bruno Sousa